it might be useful to be able to enable specific configure commands only when running tests

[Ryan Schmidt]

On Jan 18, 2020, at 17:37, Ken Cunningham wrote:

> It might be helpful if there was a configure command in the portfile that was only enabled when “port test” was run.
> 
> Specifically, for example, something that would enable the following command:
> 
> configure.args-replace --disable-tests --enable-tests
> 
> only when tests were being run.

Not possible. The phases are independent. When the configure phase runs, it has no idea whether or not the test phase will be run later.