[MacPorts] #28200: inkscape @0.48.0, Revision 2 - inkscape after bad svg not working.
MacPorts
noreply at macports.org
Sat Jan 29 19:15:40 PST 2011
#28200: inkscape @0.48.0, Revision 2 - inkscape after bad svg not working.
----------------------------------+-----------------------------------------
Reporter: a.y.harano@… | Owner: macports-tickets@…
Type: defect | Status: new
Priority: Normal | Milestone:
Component: ports | Version: 1.9.2
Keywords: | Port: inkscape
----------------------------------+-----------------------------------------
Not sure if this is the right bug reporting place, but worth a try.
I use Snow Leopard in 64-bit mode (‘arch=x86_64′ boot flag in
com.apple.Boot.plist).
I had used the inkscape 0.48.0 from inkscape site and it was working. Then
I installed from MacPort and it was working. I had generated a few svg by
hand and tried to open using MacPort's. After that time, I got the message
"Inkscape encountered an internal error and will close now." each and
every time that I open inkscape, forcing to quit just after it starts to
run. I had uninstalled both versions (from the website and MacPort's) and
tried to reinstall MacPort's several times (cleaing all, uninstalling and
installing, rinse and repeat). The error only occoured in MacPort's.
I managed to install as described in section "Compiling Inkscape with
native GTK using MacPorts [experimental]" from
http://wiki.inkscape.org/wiki/index.php/CompilingMacOsX (it needed a
unlisted dep "xorg-libx11"). Even so, it keeps appearing the same error
("Inkscape encountered an internal error and will close now.") and close
just after appearing.
The attached file is Snow Leopard's generated log after running using the
native GTK (copy-paste).
Is it related to any log or setting file? If so, where do I have to check
for them?
--
Ticket URL: <https://trac.macports.org/ticket/28200>
MacPorts <http://www.macports.org/>
Ports system for Mac OS
More information about the macports-tickets
mailing list