[MacPorts] #37342: Work on eCos eabi toolchain

[MacPorts]

#37342: Work on eCos eabi toolchain
-------------------------+--------------------------------
  Reporter:  billy@…     |      Owner:  macports-tickets@…
      Type:  submission  |     Status:  new
  Priority:  Normal      |  Milestone:
 Component:  ports       |    Version:  2.1.2
Resolution:              |   Keywords:
      Port:              |
-------------------------+--------------------------------

Comment (by billy@…):

 Replying to [comment:1 mfeiri@…]:
 > http://gcc.gnu.org/bugzilla/show_bug.cgi?id=32332

 Thank you mfeiri. I disabled objc from the --enable-languages configure
 option and it builds cleanly now. The "Official" eCos toolchain is built
 without Objective C so I may just leave it at that. I will try to build
 with the eCos headers (without newlib) next. The eCos instructions
 referenced above indicate I should copy those under ${worksrcpath}/sys-
 include/include and then use --with-newlib. Those directories don't exist
 in the newlib build I just did so I'm not quite sure if that will work.
 There is also a eCos patch set I need to apply and will try it as well. I
 also noticed that when I continued with the full install I got an arm-
 eabi-gcc-4.3 instead of the arm-eabi-gcc I was looking for. I need to
 figure out how to limit the installed binary to arm-eabi-gcc. I'll post my
 progress here for anyone interested.

-- 
Ticket URL: <https://trac.macports.org/ticket/37342#comment:2>
MacPorts <http://www.macports.org/>
Ports system for Mac OS