[MacPorts] #36474: Perl 5.12 Config.pm gets wrong gcc

[MacPorts]

#36474: Perl 5.12 Config.pm gets wrong gcc
-----------------------------+--------------------------------
  Reporter:  macports.org@…  |      Owner:  macports-tickets@…
      Type:  defect          |     Status:  new
  Priority:  Normal          |  Milestone:
 Component:  ports           |    Version:  2.1.2
Resolution:                  |   Keywords:
      Port:                  |
-----------------------------+--------------------------------

Comment (by ryandesign@…):

 I suspect you either installed perl5.12 while you had Xcode 3 (before you
 upgraded to Xcode 4), or else you received a pre-compiled binary of
 perl5.12 from our Snow Leopard buildbot, which uses Xcode 3 at this time.

 Because you are using a different Xcode than our buildbot (in particular
 an Xcode that has a different default compiler, and even more in
 particular an Xcode that no longer contains the compiler that our
 buildbot's Xcode uses by default), I suggest you disable the use of pre-
 compiled binaries in macports.conf (set "buildfromsource" to "always")
 then rebuild perl5.12:

 {{{
 sudo port clean perl5.12
 sudo port -n upgrade --force perl5.12
 }}}

 perl5.12 is not the only port that will "remember" the compiler it was
 used with, so you might have other ports already installed that you need
 to rebuild.

-- 
Ticket URL: <https://trac.macports.org/ticket/36474#comment:3>
MacPorts <http://www.macports.org/>
Ports system for Mac OS