[MacPorts] #37356: octave-devel @ 3.6.3 -- can't use fltk toolkit

[MacPorts]

#37356: octave-devel @ 3.6.3 -- can't use fltk toolkit
---------------------------+-------------------------
  Reporter:  cdemills@…    |      Owner:  michaelld@…
      Type:  defect        |     Status:  reopened
  Priority:  Normal        |  Milestone:
 Component:  ports         |    Version:  2.1.2
Resolution:                |   Keywords:
      Port:  octave-devel  |
---------------------------+-------------------------

Comment (by cdemills@…):

 Replying to [comment:7 michaelld@…]:
 > First, do the following to see if it works:
 > {{{
 > sudo port install octave-devel +fltk +accelerate +gcc45
 > }}}
 >
 > Not sure if this makes any difference, but some of your installed ports
 are +gcc45 while others are +gcc47. Unless you cannot do otherwise, I
 strongly advise you to replace those with +gcc45 with +gcc47, then remove
 gcc45 and all of the old non-active cruft. In my experience, mixing GCC
 versions between various ports is a setup for serious issues down the
 road.

 OK. Trying to migrate everything to +gcc47. While trying to remove gcc45,
 I got a message about atlas and arpack depending on it.  So I rebuilt both
 with +gcc47, and uninstalled the gcc45 version. The strange thing is that

 {{{port list variant:gcc45}}}


 still shows atlas and arpack in the list. Is there some way with the port
 command to display, for each package, the compiler it depends from ? I
 mean, some kind of more verbose output ?

 Regards

 Pascal

-- 
Ticket URL: <https://trac.macports.org/ticket/37356#comment:8>
MacPorts <http://www.macports.org/>
Ports system for Mac OS