[MacPorts] #43482: PyMOL 1.6: Control Window broken
MacPorts
noreply at macports.org
Mon Jun 2 10:55:58 PDT 2014
#43482: PyMOL 1.6: Control Window broken
------------------------------+-----------------------
Reporter: structures-it@… | Owner: howarth@…
Type: defect | Status: new
Priority: Normal | Milestone:
Component: ports | Version: 2.2.1
Resolution: | Keywords:
Port: pymol |
------------------------------+-----------------------
Comment (by howarth.at.macports@…):
What happens if you revert mesa back to the 8.0.5-2? Does that eliminate
the problem? If not, you might consider installing fink and testing its
pymol-py27 that I also maintain. We have a binary distro again in the
current fink so it should be trivial to install. This pymol package is
based on the same pymol svn release for 1.7.1.1 so it should behave the
same.
It would be nice if we could get Jeremy to look at the delay in the top
window appearing. That issue snuck in some years ago and I tend to think
that it was introduced by an upgrade in Xquartz rather than a change in
pymol. It is very puzzling as the lag only exists for the first startup of
pymol and any additional startups (until a reboot) are instantaneous. I
have thought this might be due to the probing of the video card by pymol
but never could fathom such a lag would disappear on later startups of
pymol.
--
Ticket URL: <https://trac.macports.org/ticket/43482#comment:6>
MacPorts <http://www.macports.org/>
Ports system for OS X
More information about the macports-tickets
mailing list