[MacPorts] #51306: octave-control: configure failure

[MacPorts]

#51306: octave-control: configure failure
-----------------------------+-------------------
  Reporter:  gps@…           |      Owner:  mps@…
      Type:  defect          |     Status:  new
  Priority:  Normal          |  Milestone:
 Component:  ports           |    Version:  2.3.4
Resolution:                  |   Keywords:
      Port:  octave-control  |
-----------------------------+-------------------

Comment (by gps@…):

 Replying to [comment:5 mps@…]:
 > I just installed octave-control against octave-devel-release (octave
 4.0.1) under El Capitan and Xcode 7.3.1, w/o any problems.
 >
 > Try
 >
 > sudo port clean octave-control
 >
 > sudo port install octave-control
 >
 > as there may be remnants of a previous build.

 Thanks for you're response.  This is the first ticket that I've filed and
 did not fully understand the formatting conventions. I apologize.

 I completely uninstalled macports including deleting all macports
 residuals per the "uninstall" page.  I reinstalled macports from scratch
 and per your suggestion installed octave-devel-release rather than octave.
 I also did a "port clean octave-control" just in case.   I then installed
 octave-control and ran into the same issue as before.

 I do see your notes above about the loader errors.    From the log file it
 appears that octave-control is linking to /opt/local/lib/octave/3.8.2
 rather than /opt/local/lib/octave/4.0.1.     I'm not sure how to proceed
 here and would appreciate any suggestions.  I will attempt to upload the
 latest log file as well.   Thanks for your help.

-- 
Ticket URL: <https://trac.macports.org/ticket/51306#comment:6>
MacPorts <https://www.macports.org/>
Ports system for OS X