[MacPorts] #51359: qhull fails to build on 10.6.8

MacPorts noreply at macports.org
Sat May 21 05:08:54 PDT 2016


#51359: qhull fails to build on 10.6.8
---------------------------+---------------------
  Reporter:  dyne2meter@…  |      Owner:  mmoll@…
      Type:  defect        |     Status:  new
  Priority:  Normal        |  Milestone:
 Component:  ports         |    Version:
Resolution:                |   Keywords:
      Port:  qhull         |
---------------------------+---------------------

Comment (by dyne2meter@…):

 Replying to [comment:15 braumann@…]:
 > Replying to [comment:14 dyne2meter@…]:
 > > No, this does not work on the Intel platform, 10.6.8, with gcc5.
 Should I abandon gcc5 and go to gcc6? This is delaying upgrades of
 py##-matplotlib and octave. I have a Mavericks installation where the
 update of qhull proceeds normally.
 >
 > Oh, I expected you to work on 10.5.8 Intel. However, if I remember
 right, on my 10.6.8 64 bit Intel machine qhull could be built without a
 Portfile change just by specifying `sudo port -s upgrade qhull
 configure.compiler=macports-gcc-5` in the command line. To be honest, I
 was a bit surprised that no complaint came up concerning the `-arch`
 switch on that machine. Anyway, I do not think that `gcc6` would solve
 your issue. What is the error being issued on your 10.6.8 machine?

 The errors are the same as those in my initial report.

-- 
Ticket URL: <https://trac.macports.org/ticket/51359#comment:16>
MacPorts <https://www.macports.org/>
Ports system for OS X


More information about the macports-tickets mailing list