[MacPorts] #65293: qmake5 PortGroup only works if use_xcode yes is applied to every PortFile that uses it: Project ERROR: Could not resolve SDK Path for 'macosx11' using --show-sdk-path

[MacPorts]

#65293: qmake5 PortGroup only works if use_xcode yes is applied to every PortFile
that uses it: Project ERROR: Could not resolve SDK Path for 'macosx11'
using --show-sdk-path
--------------------------+--------------------
  Reporter:  cooljeanius  |      Owner:  (none)
      Type:  defect       |     Status:  new
  Priority:  Normal       |  Milestone:
 Component:  ports        |    Version:  2.7.2
Resolution:               |   Keywords:
      Port:  qtads        |
--------------------------+--------------------

Comment (by markmentovai):

 This bug was mentioned at https://github.com/macports/macports-
 ports/pull/15136#issuecomment-1159482792.

 If you’re experiencing this, can you run

 `grep -Er '^QMAKE_MAC_SDK\s*=' /opt/local/libexec/qt*`

 and share the output? Based on the error message reported, it sounds like
 it’s showing up as `macosx11` when it should have been detected as
 `macosx`.

-- 
Ticket URL: <https://trac.macports.org/ticket/65293#comment:12>
MacPorts <https://www.macports.org/>
Ports system for macOS