ncurses breaks gawk trying to build py27-wxpython

[Dave Curtis]

On Mar 20, 2012, at 5:14 PM, Ryan Schmidt wrote:

> 
> On Mar 20, 2012, at 18:37, Ryan Schmidt wrote:
> 
>> On Mar 20, 2012, at 12:39, Dave Curtis wrote:
>> 
>>> david-curtiss-macbook:wxtab dave$ gawk
>>> dyld: Library not loaded: /opt/local/lib/libiconv.2.dylib
>>> Referenced from: /opt/local/bin/gawk
>>> Reason: Incompatible library version: gawk requires version 8.0.0 or later, but libiconv.2.dylib provides version 7.0.0
>>> Trace/BPT trap
>> 
>> The short answer is that you need to rebuild libiconv +universal, or follow the Migration instructions if applicable. This has come up so often on the list and in the issue tracker since Snow Leopard's release three years ago that it's time for me to write a ProblemHotlist entry for it. I'll reply here again when I've written it.
> 
> https://trac.macports.org/wiki/ProblemHotlist#libiconv-version
> 
Hmmm... OK, I'll give that a shot.  To be honest, I'm not sure of the migration state of this system. I *think* it is correct(*), but this symptom would indicate something is a bit off kilter.   I'll try the recommended procedure and see if that helps.

Thanks,
   Dave

* The reason I think I should be good w.r.t. migration is, first off, when I did  the original migration from Leopard to Snow Leopard, I *did*attempt to follow the instructions.  Then some time later the hard disk seized up and was replaced -- I rebuilt ports on SnowLeopard pretty much from scratch at that point.  But... both of those events were a long time ago so my memory is pretty fuzzy.