gdk-pixbuf2 failed

[Ryan Schmidt]

On Sep 21, 2012, at 22:58, Frank J. R. Hanstick wrote:

> On Sep 21, 2012, at 8:19 PM, Ryan Schmidt wrote:
> 
>> On Sep 21, 2012, at 22:09, Frank J. R. Hanstick wrote:
>> 
>>> On Sep 21, 2012, at 5:47 PM, Ryan Schmidt wrote:
>>> 
>>>> On Sep 21, 2012, at 19:08, Frank J. R. Hanstick wrote:
>>>> 
>>>>> While trying to upgrade, the following error occurred during configuration:
>>>>> 
>>>>> :info:configure checking for GLIB - version >= 2.31.0...
>>>>> :info:configure *** 'pkg-config --modversion glib-2.0' returned 2.32.4, but GLIB (2.28.8)
>>>>> :info:configure *** was found! If pkg-config was correct, then it is best
>>>>> :info:configure *** to remove the old version of GLib. You may also be able to fix the error
>>>>> :info:configure *** by modifying your LD_LIBRARY_PATH enviroment variable, or by editing
>>>>> :info:configure *** /etc/ld.so.conf. Make sure you have run ldconfig if that is
>>>>> :info:configure *** required on your system.
>>>>> :info:configure *** If pkg-config was wrong, set the environment variable PKG_CONFIG_PATH
>>>>> :info:configure *** to point to the correct configuration files
>>>>> :info:configure no
>>>>> :info:configure configure: error:
>>>>> :info:configure *** GLIB 2.31.0 or better is required. The latest version of
>>>>> :info:configure *** GLIB is always available from ftp://ftp.gtk.org/pub/gtk/.
>>>> 
>>>> And what version of the glib2 port is actually installed?
>>>> 
>>>> port installed glib2
>>>> 
>>>> The version currently available in MacPorts is 2.32.4 which should satisfy the above requirement.
>>> 
>>> glib2 @2.32.4_0 (active)
>> 
>> I see, that is odd then.
>> 
>> Could you attach the config.log? It should be in this directory:
>> 
>> /opt/local/var/macports/build/_opt_local_var_macports_sources_rsync.macports.org_release_ports_graphics_gdk-pixbuf2/gdk-pixbuf2/work/gdk-pixbuf-2.26.4
> 
> 	Right where you said it would be:
> 
> <config.log>

Thanks. The config.log unfortunately doesn't shed any light on why this check failed; it merely reiterates that it failed.

I see you're on a G4 with Leopard. In case this was something PowerPC- or Leopard-specific I tried on my G4 with Leopard, but it built this version of gdk-pixbuf2 just fine.

Do you perhaps have an older copy of glib2 (version 2.28.8) installed somewhere else, such as in /usr/local? If so, move /usr/local out of the way, clean the port and try again.