Scott Haneda talklists at newgeo.com
Sun Nov 8 19:14:52 PST 2009

Looking at the Portfile, it looks like things go into ${prefix}/share/ 
qt3, so probably /opt/local/share/qt3

You can try `which qt3-mac` which may show you the path, but you  
should already have your path set to locate it.

See this section http://guide.macports.org/ 
#installing.shell.postflight about $PATH if when you run `echo $PATH`  
in the terminal, you do not see the location of qt3-mac in that path.

Also, try `port contents qt3-mac` which will show you every single  
piece of software that was installed for that port.
Scott * If you contact me off list replace talklists@ with scott@ *

On Nov 8, 2009, at 1:21 PM, wilfried rabaud wrote:

> Hello,
> I have installed the qt3-mac port (all goes fine) to compile qcad  
> from the source . To do so, I have to set the env. variable QTDIR  
> and QMAKESPECS, but infortunately I am not able to find the  
> executable files for Qt3. Does anyone knows where is located this  
> executables?
> MacPort 1.8
> 10.5.8 Leopard

More information about the macports-users mailing list