Portfile for iAIDA and CLHEP

[Cristiano Fontana]

I found the problem in CLHEP!
The compiler set in the configure phase is g++-4.2 and the configure did not recognized it.
So I patched all the configures and now it seems to work. I am putting the portfile to the trac page.

Il giorno 11/gen/2010, alle ore 16.36, Andrew Stromnov ha scritto:

> Hi!
> 
> iAIDA compiles perfectly, but installed into the wrong place:
> ${prefix} instead of ${destroot}${prefix}.
> 
> Try to adjust Makefile.in files (./Makefile.in, ./src/Makefile.in and
> others) by reinplacing '@PREFIX_DIR@' with ${destroot}${prefix}.
> 
> So, native build system of iAIDA installs all data into
> ${destroot}${prefix}, and then macports install system maps
> ${destroot}${prefix} to ${prefix}.
> 
> Note: after installation aida-config script MUST point to ${prefix},
> not ${destroot}${prefix}
> 
> On Mon, Jan 11, 2010 at 15:47, Cristiano Fontana
> <cristiano.fontana at gmail.com> wrote:
>> Hello,
>> 
>> this is my first try in writing a portfile. Unfortunately this was an unsuccessful one, so I would like to have some help from some more experienced users.
>> I tried to write a portfile for a library used in High Energy Physics: CLHEP. It seemed pretty straightforward since the installation procedure is the canonical configure; make; make install, but it does not want to compile.
>> Same problem with iAIDA.
>> I attached both the portfiles.
>> 
>> Thanks!
>> 
>> _______________________________________________
>> macports-dev mailing list
>> macports-dev at lists.macosforge.org
>> http://lists.macosforge.org/mailman/listinfo.cgi/macports-dev
>> 
>>